What To Spray On Vinyl Stickers To Position Before Drying

Many clear coat paints will remove or tarnish and smear printed decals.

What to spray on vinyl stickers to position before drying.

In one pint of water. There are three ways that you can seal craft projects including those with vinyl. You want to make sure that your vinyl adheres well and that nothing comes up with the transfer paper. The wet application method applies a vinyl graphic to a substrate by using a fluid to assist with positioning.

A clear coat or several can add pristine uniform gloss. With your spray bottle mix a solution of 4 5 drops of joy ivory etc. Fresh paint can also cause problems. Now carefully spray a mist of water on the area you want to place the decal and on the sticky side of the decal.

Outgassing can also occur in some plastics and insufficiently dried paints resulting in adhesive failure of vinyl films applied over them. Those who are still learning need the flexibility that wetting solutions can offer. The dry method as its name indicates does not use fluid but rather depends on the skill of the installer to correctly position the film. Reflective vinyl should be applied on a dry surface.

Do not spray water or application fluid when using reflective vinyl. Place the left side of the decal down on the surface taking care to line up the lines you drew in the previous step. Spray the surface on the left side with water or application fluid we recommend the application fluid. Peel the decal with the transfer masking tape up off of the paper backing.

Likewise if you use soap and water and do not clean it off adequately then you could be leaving a thick layer of soap residue on the substrate. Experts recommend allowing at least three weeks to pass before adhering film to paint that has been oven dried or baked.